Starlink Storage Case DIY Instructions
Savage UTV Starlink Case Lid Mount Instructions
Tools needed
Glue gun (recommended) or general adhesive
¼” drill bit and drill gun
1.75” hole saw
Phillips head screwdriver and 3/8” socket or wrench
Hardware included: (1) Aluminum Plate, (1) Mounting Base, (4) Bolts, (4) Nuts, (8) Washers
Step 1. Place the black aluminum plate with the (4) small holes and (1) large hole, in the middle of your case over the HUSKY logo as shown below.
Step 2. Mark the 4 small holes in the corners and drill them using a ¼” bit.
Step 3. Mark and drill the center of the large hole using a 1-3/4” hole saw.
Step 4. Use the hardware included to bolt in the aluminum plate to the lid through the holes you just drilled.
Step 5. Screw in the round, mounting base from the bottom of the case lid as shown below, then screw the cap on to the mounting base.
Savage UTV Starlink Inside Case Instructions
Foam Included:
Two (A), Two (B), Two (C), One (D), One (F) and One (G)
Step 1. Glue 2 (A) foam pieces to the left side of the base of the case as shown below.
Step 2. Glue 2 (B) foam pieces to the right side of the base of the case as shown above.
Step 3. Glue 2 (C) foam pieces to the front and back of the base of the case as shown above.
Step 4. Place foam (D) into the bottom of the base of the case as shown above.
(Not necessary to glue this foam piece, but you can.)
Step 5. Place foam (E) on top of foam (D) as shown below.
(Not necessary to glue this foam pieces together, but you can.)
Step 6. Foam (F) sits on top of foam (E) once your router is stored in the case.
(Do not use adhesive on foam (F) as it needs to be removable)
Step 7. Foam (G) sits on top of your Starlink dish once it is placed in the case with the white side of the dish facing up. See image below.